9mm primed cases from pull down ammunition. This is new never fired primed brass that was loaded and had to have the bullet pulled due to powder charge. Head stamps include but are not limited to Ammo INC 9mm Luger, Jag, A U.S.A, and G.F.L. 500 pack. This is pull down brass. It might have minor dents, and we suggest running the brass through a neck sizing die while loading. We have tried to remove all powder form cases but are finding some compressed powder is still in the cases, make sure you inspect every case before loading.  You are purchasing primed Brass cases. This is not complete live ammunition.
WARNING:Â PLEASE INSPECT EVERY CASE PRIOR TO USE.
Combat Disabled Veterans Surplus assumes no liability for any defective or marred products and all products are sold as-is. You need to have adequate education to load live ammunition, and apply a lot of common sense. Loading live ammunition is dangerous. Improperly hand-loaded ammunition can cause serious personal injury. Hand loading should be done only by a competent adult, and only after proper instruction. Since hand-loading operations are beyond our control, we disclaim all liability for any damages that may result.
icewalker2112 (verified owner) –
Great find! I purchased a lot of 500 and have now reloaded over 400 cartridges. I checked all 500 in a Lyman chamber gage and only 15 cases failed. I resized these and all but five passed the gage after sizing. The 5 that didn’t pass were an odd type of case design even though they were part of the same lots stamped AMMO Inc. I ran all of the cases in the mouth expanding die and another lot of 8 were obviously not forming correctly. When I looked at these, they had the same case design as the ones that failed the chamber gage. I discarded these. I then charged, seated bullets of various types of weights, checked them in the chamber gage, and fired them in my Sig Sauer P365. 100% went bang and accuracy was well within expectations. Bottom line: I will purchase more of these and inspect for the odd cases again. I am extremely pleased with this purchase and they work great with no signs of case failures or primer pressure problems after firing. Thanks CDVS for a great find!!